Dataprobe iBoot-G2 Specifications download pdf (Page 3)

V140602E iBoot-DC Page 3

3. Hardware Installation

3.1. Ethernet Connections

iBoot-DC supports 10/100 Ethernet using the cable supplied, or other suitable

unshielded twisted pair (Cat 5) cabling. Link (amber) and Activity (green)

LEDs on the network connector indicate when the network connection is

properly established.

3.2. DC Power Connections

iBoot-DC uses screw terminal connections for the DC input and switched

output connections. The screw terminals can be removed to facilitate

connection and cable fabrication.

Maximum Operating Current

5.0 to 29.9 VDC

5 Amps

30.0 to 48.0 VDC

2 Amps

The Positive lead is switched. When ON, the power will be at the NO connection. When OFF, the power

will be at the NC connection.

The chassis ground is optional and not switched.

An LED Indicator market Output will be on when the power to the NO connection is On.

3.3. Connecting Negative Voltages

iBoot-DC will accept a negative (relative to ground) power source i.e. -48VDC. Insure the power leads are

connected so that "+" terminal voltage is positive RELATIVE to the "-" terminal voltage.

Do Not connect Chassis Ground when using –VDC Power.

Connect 10/100 Ethernet

1 2 3 4 5 6 7 8 ... 23 24

No comments

Dataprobe iBoot-G2 Specifications Page 3