Dataprobe iBoot-G2 Specifications download pdf (Page 15)

V110120E iBoot-G2 Page 15

Network Commands

All set commands require a reboot before they take effect. These commands

are only available to the administrator.

get network

This command will return all the network settings as shown

below:

Mode: static

IP Address: 192.168.1.254

Subnet Mask: 255.255.255.0

Gateway: 192.168.1.1

HTTP Port: 80

Telnet Port: 23

DxP Port: 9100

Timeout: 2

set ipmode <static | dhcp> This command sets the ip address setting mode. Static mode

locks the address as set, dhcp mode allows DHCP server to

assign address.

set ipaddress <dotted

decimal>

This command is used to set the iBoot-G2’s ip address.

192.168.1.254

set subnet <dotted decimal>

This command is used to set the iBoot-G2’s subnet mask. 255.255.255.0

set gateway <dotted decimal> This command is used to set the Gateway 192.168.1.1

set http port <0-65535> This command sets the port that the iBoot-G2’s web server

listens for incoming connections on. When set to 0 the web

server is disabled.

set telnet port <0-65535>

This command sets the port that the iBoot-G2’s Telnet server

listens for incoming connections on. When set to 0 the Telnet

server is disabled

set dxp port <0-65535>

This command sets the port that the iBoot-G2’s DxP protocol

service listens for incoming connections on. When set to 0

the Protocol service is disabled.

Note: At least one of the above MUST NOT be 0. The CLI

will protect against all 3 from being set to 0.

9100

set timeout <0-999> This command sets the automatic network timeout in minutes 2

Autoping Commands

These commands require a reboot before they will take effect. These

commands are available to the administrator only.

get autoping

This command returns all of the AutoPing settings as shown

below.

AutoPing 1 AutoPing 2

IP Address: 192.168.233.254 192.168.233.154

Frequency: 10 10

Fail Count: 3 3

--------------------------------

Mode: Single

Action: Cycle Once

set autoping <1 | 2> ipaddress

This command is used to set the IP address of AutoPing 1 or

AutoPing 2

0.0.0.0

set autoping <1 | 2> frequency

<1-999>

This command is used to set the frequency (how often the

iBoot-G2 sends the ping) for each of the AutoPings.

set autoping <1 | 2> failcount

<1-999>

This command is used to set the number of consecutive

failures the AutoPings must detect before the AutoPing

considers the pinged device to be failed.

set autoping mode <single | Sets single AutoPing (AutoPing 1) or two AutoPing Single

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21

Comments to this Manuals

No comments

Dataprobe iBoot-G2 Specifications Page 15

Comments to this Manuals

Related products and manuals for Network switches Dataprobe iBoot-G2