Dataprobe iBoot-G2 Specifications download pdf (Page 6)

Page 4

4 Installation

4.1 Ethernet Connections

iBoot-G2 supports 10/100 Ethernet using the cable supplied, or other suitable unshielded twisted

pair (Cat 5) cabling. Link (amber) and Activity (green) LEDs on the network connector indicate

when the network connection is properly established.

4.2 AC Power Connections

Connect the device to be powered ON and OFF to the

IEC receptacle marked A/C Output. An IEC 320 to

North American (NEMA 5-15) power cord is included

for connecting the iBoot-G2 outlet to the device to be

controlled.

If a cord with a different terminating receptacle is

required, be sure it is properly rated and meets all the

required local electrical standards. If the device to be

powered uses an IEC320 receptacle and detachable

power cord, an IEC to IEC extension cord can be used.

The iBoot-G2 can be connected to a power strip to

allow simultaneous control of multiple devices.

Make sure that the combined load of all controlled

devices does not exceed 12 Amps for 105-125VAC or

10 Amps for 210-240VAC.

An LED Indicator next to the Switched Outlet will be

On to indicate that the power is On at that outlet. This

LED will turn Off to indicate that the power is Off to the

outlet.

Connect the supplied power cord to the connector

labelled A/C Input, and the other end to your AC

source. If a power cord with a different terminating

plug is required, be sure it is properly rated and meets

all the required local electrical standards.

Connect 10/100 Etherne

Outlet Cord for

North America

Source Additional

Outlet Cables

Locall

1 2 3 4 5 6 7 8 9 10 11 ... 16 17

No comments

Dataprobe iBoot-G2 Specifications Page 6